UARUEN
Request estimate
All servicesFire protection system design↗Fire detection and alarm↗Fire suppression systems↗System maintenance↗Other systems↗Passive fire protection↗Contacts
UARUEN
About the system

Fire warning and evacuation control in Kyiv and Ukraine

A fire warning and evacuation control system delivers clear emergency information and supports an orderly response. We select audible, visual and voice alarm devices, zoning, standby power and interfaces with other building systems.

KABO GROUP reviews the available information, prepares an agreed technical scope and completes the work with the defined documentation.

Solutions

What is included in fire warning and evacuation control

Warning and evacuation strategy

Inputs, system interfaces and completion evidence are agreed before work begins.

Open section↗

Design and zoning

Inputs, system interfaces and completion evidence are agreed before work begins.

Open section↗

Installation and programming

Inputs, system interfaces and completion evidence are agreed before work begins.

Open section↗

Audibility and integrated testing

Inputs, system interfaces and completion evidence are agreed before work begins.

Open section↗
Practical guide

System details and solution selection

Warning zones and evacuation sequence

The design defines zones, priorities, delays, messages and the responsible staff's manual control arrangements.

Audibility and intelligibility

Device positions reflect background noise, acoustics, partitions and occupancy; voice systems must deliver understandable instructions, not simply high sound levels.

Resilience and circuit supervision

Testing covers primary and standby power, circuit monitoring, message priorities, fire microphones and evacuation-door interfaces.

Regulatory basis

Regulations and standards considered

This list explains the regulatory basis but is not a substitute for a project or a complete schedule for every building. Document status, amendments and building-specific requirements are verified when the project starts.

Building regulation

DBN V.1.1-7:2016 — Fire safety of construction objects

Sets general fire-safety, fire-resistance, evacuation, compartmentation and engineering requirements.

Open source↗Building regulation

DBN V.2.5-56:2014 — Fire protection systems, with amendments

Covers design and installation of fire-protection systems, their scope, interfaces and principal requirements.

Open source↗Technical standards

DSTU EN 54-16, DSTU EN 54-24 and relevant EN 54 parts

Covers voice alarm control equipment, loudspeakers, circuit supervision, power supplies and fire alarm interfaces.

Open source↗Mandatory rules

Fire Safety Rules in Ukraine, Ministry of Internal Affairs Order No. 1417

Sets organisational and operational duties, including system readiness and measures during isolation or repair.

Open source↗
Outcome

One accountable delivery cycle

Warning and evacuation strategy✓Design and zoning✓Installation and programming✓Audibility and integrated testing✓
Process

Work stages

Scenario definition

We agree warning priorities, evacuation phases, zones, messages and system interfaces.

System design

We select control equipment, sounders, beacons, loudspeakers, microphones, circuits and standby supplies.

Installation and programming

We install devices and circuits, then configure zoning, messages, priorities and control logic.

Testing and handover

We check audibility, intelligibility where applicable, visual indicators, fault monitoring, standby power and connected systems.

FAQ

Common questions

Which warning methods can be used?+

The design may use audible alarms, visual indicators, voice messages, zoning and a fire microphone depending on the building and evacuation strategy.

Is the warning system part of the fire alarm?+

It is a distinct function activated through the approved cause-and-effect and coordinated with fire detection and other building systems.

What is tested after installation?+

Zone activation, audibility, intelligibility where required, visual indicators, priorities, fault monitoring, standby power and interfaces.

What determines the price?+

The warning type, building acoustics, number of zones, equipment, circuits and the required evacuation and integration logic.

Short request

Request a preliminary estimate

By submitting, you agree to data processing for the purpose of answering your request.